|
The MotoDriver 2 is an expansion board which can be connected fast and easily to your single-board-computer. It enables either the controlling as well as the power supply of two direct current motors. Additional power supplies for the motors or a huge amount of cables are not necessary anymore. The expansion board enables the control with a constant voltage between 5 to 35 V.
Features:
- Uses an L298N chip as the main driver, driving ability, low heat, strong anti-interference ability.
- Can use the built-in 78M05 to take power by driving the power section, but in order to avoid damage to the regulator chip, when use is greater than the drive voltage of 12V, use an external 5V logic supply.
- The module uses a large-capacity filter capacitors, drain diode can improve reliability.
Tekniske detaljer:
- Operating mode H-bridge driver (dual)
- Master chip: L298N
- Logic voltage: 5V
- Drive voltage: 5-35V
- Logic Current 0-36mA
- Drive current: 2A (maks. single bridge)
- Maximum Power: 25W
- Vægt: 30g
- Størrelse: 43 x 43 x 27mm
Application examples:
- 1: drive stepper motor. Drive ordinary 4-wire 2-phase motor connection.
- 2: drive DC motor. This module is a 2-channel H-bridge driver can drive two motors at the same time.
Note: This is a "maker" module for developers. It is delivered without any further instructions than what you find here. |